2. misc-audio
  3. 1240167302

EMF/RFI isolation with aluminum sheet metal

Hi all. I have my Class D power amps in pretty close proximity to my DirectTV DVR, both on the bottom shelf of a double wide built-in cabinet. I'm concerned about each component (the DVR and the amps) interfering with one another (EMF/RFI). One thought I had was to just cut a piece of sheet metal to size and place it in the cabinet between them. They are about 4 inches apart I can cut the sheet metal so it will basically be as if the entire area (cross-section) of the cabinet will be filled with only minimal gaps. Is this wortwhile? Any other ideas?

thanks!

--dan
dgaylin

Showing 1 response by jea48

jea48
4,765 posts
 
I would not worry about any EMI/RFI exiting or entering through the DVR case. It has to meet FCC regulations for such things. More so exiting than entering. But it works both ways.....

That does not however stop EMI/RFI from going back out on the power cord and contaminating the power supply of the amp and other associated analog equipment if the DVR shares the same receptacle and branch circuit.
More to discover