Electrical supply home wiring project


Hello all,

I am looking for some helpful suggestions in designing my electrical power supply to my combined home theatre and two channel system. All of my components are presently solid state.

I have two 20amp circuit breakers that I intend to dedicate to my system. My circuit breaker box is about 20 feet from my system. I am having a licensed electrician do the work.

Here are the components to my system. A 52 inch LCD television, TIVO DVR, Yamaha RX-Z9 AV receiver, universal disk player, Classe CA 200 amp (200 watts into 8 ohms), a Classe CP 35 preamp (line level), classe CD player, vpi turntable, Simaudio phono stage pre-amp, velodyne DD12 subwoofer, and possibly other components down the road. So I need at a minimum, 10 outlets, however, to make room for expansion I should probably plan to have 12 to 14 outlets.

I am looking for recommendations on how to provide these outlets. Should they all be hard wired, should I use audio grade outlets or separate line conditioners? How should I configure the outlets to minimize interference? Any recommendations on the type and gauge of wire? Should I use separate power conditioners or power conditioning outlet strips?

Any help or suggestions would be appreciated.
papajoe

Showing 1 response by drummermitchell

I had my electrician friend run me a line from my main panel,
I believe is 6 or 7 gauge,the two breakers in the main are 40a.he installed a sub panel in the living room(8-15a breakers)which gave me 8 receptacles(16 power inputs).
My audio techs recommended 10 gauge wire for the sub and receptacles(that's what we did).I use TORUS power isolation
on my components and amps(HUGE,HUGE,HUGE difference),as the
Torus(Bryston website) will give you up to 400a of short term reserve power,a wall receptacle can give you,15a,20a ect.If you go with a power conditioner,you really owe it to
YOURSELF to try one out from your Audio dealer,as I've said
before a MAJORE UPGRADE.

where the wall receptacle can give you 15a,20a,ect.