Dynavector DV501 with a Grado?

I was wrong. I got home, took the AT1000 off and found slotted, not two holes as I remembered. 11.6 grams is what I measured. The Orsonic on the other hand does not look as though it can be used at all with a top threaded cart. Teach me to post from the office.

Best Regards

Bill

I've got two Orsonic headshells.  I would have thought you could use it with any cartridge.  When you say you cannot use it with a threaded-hole cartridge, do you mean because the Orsonic has threaded holes in its carrier piece?  I will check that. I own the AV101, which is the heaviest of the series so the limiting factor is effective mass.

It looks as though the cart is screwed down from the top. My Orsonic screws from the bottom.

Grado Signature3 came yesterday and the weight is11.15 grams. The screws weigh 1.2 grams. I mounted it on one of my DV headshells and combined weight 26.75 grams. I thought it might work. In reality, my stock sub-weight is too light. I can achieve balance at the limit, but just barely. Most of my carts were in the 16+ range. I gave the larger sub-weight away to a friend years ago. I purchased an AT 9 gram headshell so I can at least use what I've got to get going. I've been told that magnesium is better for this cart so I am on the hunt. By the way, the Orsonic I have has a smaller sliding cross beam than what is made today and does require top nuts.

Bets Regards to all

Bill

Statement3 not signature. I hate the new names. Ok, headshell combo is 20.5 grams. No hum. (LO) but fighting antiskate. About 1.7g VTF and only played for an hour. Sounds like I expected. I think it will open up. I'll post again when and if it changes. One note. It is a MF to set up. the wooden body is so large that it is almost impossible to see the cantilever or stylus without a mirror. I have never owned a cart this large. With Stevenson you are all the way to the end (closest ortofon coupling) on the DV501.  Spindle/tonearm set at 226mm checked and rechecked.

best regards

bt