The Schroder M2 works with the mounting hole and geometery, but would require you to drill 3 mounting holes and either tap them, or use appropriate screws depending on which arm board you have. I know, I just swapped out an OL Silver [available BTW ;~)]for an M2. Its a bit hairy; you have to properly center the arm collar in an oversized mounting hole and then mark the mounting hole locations, then drill them accurately- A drill press is highly recommended. I did it to a monkeywood armboard and it brass (them must be non-magnetic) wood screws worked; if the wood was harder (cocobolo, ebony) or if it was a metal armboard, it would have to be drilled and then tapped for a nonmagnetic bolt (stainless or brass). NOT simple drop in like the Rega derivatives.
Drop in replacement for Rega RB300?
Hello,
Are there any arms that can be dropped in to replace a Rega arm without the need for a new armboard? I am running a RB300 in a SOTA table and just curious of other makers of arms that can just drop in to my armboard........thanks
Are there any arms that can be dropped in to replace a Rega arm without the need for a new armboard? I am running a RB300 in a SOTA table and just curious of other makers of arms that can just drop in to my armboard........thanks