Driving Dynaudio Focus 220 IIs



Hello,

I will probably buy Dynaudio Focus 220 IIs.

I'm also looking at buying an amp. I like the two below because I can use them in either US or Europe (voltage switchable easily) and I can level-match sources.

Linn Majik-I (100 watts into 4 ohms, damping factor > 170)
Arcam A38 (140 watts into 4 ohms, damping factor 30)

I really wish I understood the science better -- I don't know what to look for to match speaker + amp choice.

Any thoughts on this choice? I can't AB compare the amps. Thank you!
mshimao

Showing 1 response by silentstudios

I would agree that a powerful amp goes a long way with these. Not a requirement by any means, but very helpful IMHO.

I have owned a pair since shortly after they were released (about 2 years now) and have run them with Simaudio W6 monos, Bryston 4B-SST, and a pair of 7B-SST. The 4B couldn't quite cut it (timing, resolution, were not quite up to par compared to the monos). But upgrading to the 7B's made all the difference. The W-6's also sounded killer but not quite as neutral as the 7B's, it would come down to preference in that case. I'm currently using the 7B's. Good luck.