2. amps-preamps
  3. 1196389320

drive single channel of stereo amp

I have a dumb question,

I was told long ago that it is bad to drive an amplifier channel without a load on it. I never understood why. If you unplug the source left channel from the source to preamp is that still a bad idea to play the system with everything else plugged in? Why is it bad to drive without a load anyway?
Thanks for any help.
hahnzie

Showing 3 responses by narrod

narrod
1,064 posts
 
The amplifier needs to see a load. Just put an 8 ohm resistor across the binding posts of the unused channel.
narrod
1,064 posts
 
Depending on the design it can become unstable especially if there is an active amp. Some designs aren't bothered at all.
narrod
1,064 posts
 
My last response should have read "active input" and not "active amp".
More to discover