Doubling a Set of Speaker Cables


While reading a "professional "review of the Daedalus Audio Ulysses Floorstanding Speaker, the reviewer is adamant about the improvement TWO sets of speaker cables connected to each speaker - regardless of the brand - makes.

This is something that crossed my mind long ago, prior to reading it now, but I’ve never realistically considered trying it nor have I ever come across this in a review. At face-value it seems to me this technique would do more harm than good. I’m wondering if there are any folks on the forum using this technique of two sets of cables (and as mentioned in the article this is irrespective of bi-amping or merely using a smaller gauge) and if so, can/do you vouch for any "improvement" one should expect.

Thanks.

http://www.dagogo.com/daedalus-audio-ulysses-floorstanding-speaker-and-bass-optimization-woofer-bow-...
gdhal

Showing 1 response by davehrab

I will plead guilty to using a double run or shot gun style speaker cable set up ... I started with a single run of Ridge Street Audio Poiema !!!'s and then added a second set for all the reasons Al mentioned ... lower resistance lower inductance and lower impedance

 These are high purity silver based flat ribbon cables in cotton with no shields ... I choose them because IMO flat ribbons offer greater band width .. better noise rejection and are relatively immune to skin effect

  I started with a single run of the RSA P!!!'s and then added a second set ... the difference wasn't night and day ... more like dusk to dawn ... but all positive with no down side

 The basic metrics of Bass - Mid Range and Treble along with dynamics and sound stage show little or no change ... but the overall presentation was more relaxed and natural sounding with more swing and sway (PRAT)

 I could tell immediately that there was an improvement, but was hard put to put my finger on what improved

  My WAG is the reduction in impedance allows for faster and easier signal flow and transfer ... thus the improvements in speed .. edge detail .. trailing/decaying  transients and notes starting and stopping ... which make for a more relaxed natural presentation

  I run my set up a little differently than the conventional way shot gun set ups are run  ...rather than stacking one speaker wire set on top of the other set at the binding post ... I take each individual + and - pole of the individual speaker cable and tie them together at the amp and speaker termination this way each individual run is either positive or negative ... hopefully reducing the inductance of the + and - poles in a speaker cable that induce from the Positive run to the Return or Negative run when both are run inside the same sheathing

   If you are looking to improve something in the basic metrics of your system that is lacking ...  this won't help much ... I don't see it improving some characteristic problem in your system that is a problem ... it is more a enhancement of the general presentation sorta like waxing you car after washing it

 The washing of your dirty car brings back all the glory of that custom paint job but the waxing just brings out or enhances the custom color

 The washing is improved and enhanced by the waxing .

.



     Enter your text ...