2. amps-preamps
  3. 183004-78750

Doge 8 Clarity 2021 Phono settings

Greetings fellow AudiogoN'ers!  I recently purchased a used Doge 8 Clarity XLR 2021 edition to upgrade from my Doge 8 LP.  The line stage is a definite improvement, however I am struggling with the phono stage.  Either it has MUCH less gain than my LP, I haven't found the right settings, or it is defective.  I have tried different tubes to no avail.  I reached out to Doge via info@doge.audio but have yet to receive a response.  My cartridge is a Soundsmith Zephyr MK III.  I have a significant investment in 12AX7 tubes for the phono stage, and would prefer to get this resolved vs using an outboard phono stage.  If anyone has insight on the phono settings I would certainly appreciate it.

Ag insider logo xs@2xshamblinb
Ag insider logo xs@2x
cleeds
5,948 posts
 

Does it have enough gain to drive your amplifier to full output?

Ag insider logo xs@2x
shamblinb OP
4 posts
 

To achieve the same volume level as the LP at around 9, I have to turn the Clarity up to about 12. And it sounds like something isn't quite right with the gain.  This only applies to the phono stage, the line stage output is comparable.

Ag insider logo xs@2x
cleeds
5,948 posts
 
shamblinb

To achieve the same volume level as the LP at around 9, I have to turn the Clarity up to about 12.

That’s not unusual, and with many components you’ll get lower distortion as you open up the volume control.

And it sounds like something isn’t quite right with the gain.

What do you mean "not right"?

Ag insider logo xs@2x
shamblinb OP
4 posts
 

Thank you for the assistance. The sound is flat and not as dynamic & detailed compared to my Doge 8 LP; turning up the volume as loud as I have to, there is an audible hum that I don't hear with the LP.  I was hoping this could be resolved with the phono stage settings...

More to discover