Do your mono blocks have overload fuses? Most do.
If so, what amp fuses are they supplied with?
3A?, 4A?
14 gauge is rated to 15A so you should be good to go…
Do I need 10 gauge power cord if I have 10 gauge from panel?
I just installed some dedicated circuits with 10 gauge electrical wire. But now I have to consider replacing my amp power cords because they are 14 gauge or higher.
Is this really necessary and any recommendations on quality 10 gauge power cords that I should buy?
Showing 2 responses by johnnycamp5
It’s just physics. If a 4A fuse doesn’t blow during heavy use your likely not exceeding the 15A (14 gauge) power cords current capacity … It may or may not cause you to hear a difference, perhaps at how much voltage sag a particular setup creates, but that’s personal/subjective to each person … @pennpencil good point |