DIY question on a preamp problem could use help...

Ok, love to hear from some of you who have good technical skill to help diagnose a problem. I purchased a used Lector Zoe preamp as an upgrade project. The unit has a lot of tube hiss/rush sort of noise through both speakers. The builder is no help as I have emailed them several times and they keep telling me to use a different tube. I have tried several tubes brand new and nos , but the same tube noise all the time. The preamp is very high gain as an FYI.

I am using two 6922 tubes. I have already modified the unit to sound far better with great results. None of the mods helped with the tube hiss that was present before and after my mods. I upgraded many caps and put in a nice Goldpoint stepped Attenuator with DACT remote. Lastly I bypassed the selector switch and went direct from the RCA input to the Goldpoint as I only use one source. I upgraded the signal wire and the end result is quite stellar. Problem is this tube hiss/rush noise that is constant through both speakers. I want to fix this and greatly reduce the noise. Where do I look?

Would reducing the gain help? Should I look at the resistors on the 6922 tubes? Change the value of any of these resistors to reduce gain? Not sure where to go next? The noise is not really impacted that much at all as I turn the volume up. The tube hiss stays pretty constant regardless of volume. The signal goes from the coupling caps right to the RCA outputs with no resistors after the coupling caps or on the RCA outputs to ground.

Any ideas?