DIY Equipment and Speaker Stands

I just built some Amp stands.Purchased to butcher blocks fro Ikea.2" thick by 15x19.I put Target spikes in the bottoms.Built for 60.00.The sound has improved over when they where on the Atlantis A/V audio rack.I put a tuntable n the rack so i needed amp stands the Matching atlantis rack where 400.00 so the 60.00 i spent saved me 340.00 to buy more vinyl.

Nhorton, right on! I just finished building some stands for Sonus Faber Concertos. Mine are a touch more stylish than straight blocks, but the exact same idea; mass, mass, mass. I started with 1 standard block (8x8x16), two half-blocks (8x8x8) stacked in the center of the bottom block, with a cap block (2x8x16) on the top. I set the cap block back such that the front edge of the cap block does not extend beyond the front edge of the speaker base. This set it back about 1.5 inches of front to back center. As to finish, I used 2 coats of Dry-lok concrete sealer. This closed the finish on the block and gave me a nice surface to baint with black acrylic. I topped the cap block off with a 1/4 inch piece of industrial linoleum tile (very inert). All items available at Home Depot for about $30 and 3 hours of my time. Sound is better than any stand (including the fixed SF stands deadened with shot and sand) I have tried. I joined all my block together with Liquid Nail. I like your suggestion for the base, but you're going to drive my cost up to over $40!

Any diy ideas for the kefs xq3s.

I almost made my own stands recently but ended up with a super deal on some metal stands.Go on Esty and put 'table legs" in the search engine.There are some guys on there that will custom make some very attractive metal legs for your project.Also some others custom make wooden speaker stands and tables.Your wife can browse too. 

If you can't do it yourself, find a local carpenter.