Dimple in speaker driver cone

If you try it with your lips..Put on some soft music and turn off the lights..If it doesn't work at least you will get to know your speakers better than you ever have before.......Sorry ,,couldn't help myself.......

Thorman...

LMMFAO!!!!

...sorry Umalum...I couldnt help myself either...

(still lol..)

Come on Thorman, you can't stop there! You left out the best part - the deflowering of the slotted port...

"Dear Stereohouse Forum - It all started when a pair of twin Thiel 1.6s showed up on my doorstep. I knew it was going to be a night to remember..."

Seriously though, if it's an aluminum driver, you're going to have a hard time resolving it short of removing the driver and, dare I say it, gently massaging it as Timrhu suggests.

Good luck!

If the above "suggestions" don't work....take a thread and put a dab of super glue on the tip. Hold it to the center of the dimple till it dries. Borrow Tvad's hair dryer and warm it up a little bit, then slowly pull the dimple out.

When you are done cut the thread from the driver.

I haven't tried this myself so you will need to sign a waiver. Any one else tried the superglue/thread method?

Keep us informed.

Thank God we all still have our Good sense of Humor!