2. amps-preamps
  3. 1334610171

Digital inputs to zone 2 out

Hi, apologies if this question has been asked before. I have an Onkyo HT-RC360 receiver and an external amp (carver a500x) that I'd like to use to drive my main speakers. Ideally, I would simply connect the zone 2/preamp out from the Onkyo to the carver to drive the speakers.

My problem is that the Onkyo only outputs analog sources to zone 2; is there any way to get around this restriction?

For example, would there be a big loss in quality if I connect the headphone out of the Onkyo to the power amp? Or the headphone out of the onkyo back into an unused input of the onkyo (say tape-in) and then the zone 2 to the power amp?

Thanks!
dalig

Showing 1 response by martykl

martykl
3,578 posts
 
What is your digital source?

If you are taking the digital signal out of a disc player into a digital input on the AVR, you might be able to run a second rca cable "alongside" the set up from the disc player's analog out into an analog input on the AVR. The main zone would use the Onkyo's internal DAC and Zone 2 would see the analog output from your disc player's DAC.

Unless there's some issue at the player, or some switching issue, I'd think that this would work.

No?

Good Luck,

Marty
More to discover