2. speakers
  3. 131134-20253

Design a $60,000 Speaker - Start here

Hi Everyone,

Just thought for interest I'd talk about one of the most expensive woofers in the 10-12" varieties, the Accuton AS250-88-552 CELL, actually an 11" aluminum honeycomb sandwich construction. Retail price at hobbyist volumes: $1,400, each.

In addition to the exotic material, the suspension and motor assembly are also worthy of note, as they leave a very large amount of unobstructed space directly behind the dome, allowing it to behave most ideally like a piston.

So putting this together into say a modest 3 way with all drivers from the same company and of the same level, I estimate around $6k / pair of speakers for the drivers alone. Add the normal markups, and this is a $60k speaker.

Will it sound any good? I have no idea. I just wanted to share with you all where some of these speakers that cost as much as a luxury sedan get their prices from.  Obviously, my estimates are rough, and go up and down. The point of this is just a general expose.

Best,


E

erik_squires

Showing 1 response by willmacc

willmacc's avatar
willmacc
80 posts
 
Bump...  Sonus Faber..  the drivers on some of their lesser range look pretty cheap. I dont esp like the sound from the base tweeter they use.
Back to 60k speakers, that 11" accuton is a beast! But why 8 ohm? The parameters call.for a large box, so 2 in parallel to get a decent sensitivity rating wd mean well over 100 litres..
Another option is isobaric, using the excellent SB 9.5" satori woofer. Best ’rear end’ of any driver imo.
More to discover