2. speakers
  3. 128025-84361

Cutting below 80 HZ on my mains, so subwoofers handle deep bass?

Sorry in advance if these are obvious questions.

I recently picked up two Rythmik L12 active subs to go with my Tekton Lore towers (10" full range driver with super tweeter). The Lores do an admirable job with deep bass (down to 30 HZ) but the L12s destroy them in quality and depth of the low-end.

The towers and subs use separate pre-amp outputs, but share one volume control. The subs are set at 80 HZ and below. Because the towers and subs currently share a lot of the same frequencies (which can potentially cause the bass to be overwhelming) is it possible to add an external crossover style device to cut 80 HZ and below from the main towers? It may improve the mids and highs if the tower drivers aren’t working as hard? And the sound may seem cleaner with greater instrument separation?

Thanks!
pts

Showing 3 responses by pts

pts's avatar
pts OP
42 posts
 
Thanks for the link, it's good to know external high-pass-filters are out there and fairly inexpensive.

To anyone who's cut lower bass to their mains, did it effect how the main drivers reproduce upper bass, mids, and highs? I don't want to mess with the overall sound signature.

pts's avatar
pts OP
42 posts
 
You really do not want to cross high and low at the same 80 hz frequency. A bit higher [high pass cutoff] is recommended rather than the same as the low pass filter cut.

So maybe cut 60 HZ and below for the mains, and set the subs at 80 HZ? Then there’s still a little play between the two. I see how not drawing such a hard line with the frequencies could help not create a hole in the audio.

pts's avatar
pts OP
42 posts
 
You know, you could also just cut the subwoofer’s low pass filters instead. :)

Setting the sub’s low pass to 30 HZ isn’t really worth it for 2 channel music. Maybe if I was configuring this for movies it would be a different story.
More to discover