2. amps-preamps
  3. 154699-140500

comparing two pre-amp/phono section buying scenarios, so weigh in!

Hi. First time poster. Based on what you know about phono stages, and assuming the cost is about identical, would you suggest (assuming the specific equipment below):
1. buy a used Conrad Johnson ET3 with the on board phono stage (assuming the correct gain setting for the cart HG or LG)
or
2. buy the same used Conrad Johnson ET3 (line stage only) and then buy a a $400 Moon 110 LP V2 phono stage.
again: the cost total is about identical, save the cost of interconnects.

My equipment may or may not be relevant to your answer, but I have a project Debut Carbon TT with an ortofon Blue cart, but that will eventually change with my next upgrade. I'm replacing an 80s era SS Mcintosh pre amp and I'm running Thiel 1.7s with a Rotel RB-1582MKII
Thanks for any help
rakod
rakod OP
5 posts
 
@atmasphere 

If/When I move away from this TT (and possibly this cart, which is a high gain unit requiring a low gain setting), it's quite possible I'll move to low output. Sure. Trying to keep options open...I move slowly on these things.
Thanks
atmasphere7,969 posts02-13-2020 11:07amFor that kind of money you have a lot of options.
Do you have or are you planning a low output moving coil setup?
atmasphere's avatar
atmasphere
11,794 posts
 
If I were to stay with the CJ line section I'd simply have the CJ phono section installed. An internal phono section doesn't have connectivity problems (if you've ever heard how an interconnect cable can change the sound then you know what I'm talking about).



rakod OP
5 posts
 
@atmasphere 
that's also a good point. Score one for the native phono!
More to discover