2. analog
  3. 1313617416

CJ PV-10 no sound

I installed a couple of GE 12AT7WA's (bp triple mica, aquired on E-Bay)into my CJ PV-10 today, and as soon as it came on, snapping sound and a hum. Now, no sound coming from pre-amp. It appeard as if one of the tubes shined brighter than it ought to prior to this happening. I'm going to go and get a new fuse to rule that out, but it looks OK. (BTW, so much for a the tube tester. Tested very good, no shorts!). On a seperate note, if I'm not able to get it fixed right away, I've tried running my NAK 670zx directly to my Classe 15 amp, and running my X-Ray CD player through the cassette deck. Sounds great (although I ALWAYS miss my tube sound). Any problem with this? Thanks
countryjazz2

Showing 1 response by microstrip

microstrip
180 posts
 
I would also suggest a power supply fault - the PV10 has a series pass HV regulator using an MJ340 , a MPSU10 and a MPSU60 transistors. Most probably the fault will be in first two transistors - the third one is just a current source to bias the zener diodes used as regulators.

As they are inexpensive I would risk replacing them if there is no HV at all at some parts of the tube sockets.

I have owned several cj preamplfiers and amplifiers for a long time and the few problems caused by defective tube problems were always solved replacing just these three transistors.
More to discover