I don't know the effective mass of the TQ-1, but it is a very short arm, so it is probably quite low mass. The bearing system is somewhat slack for the linear tracking movement. I would recommend a high compliance type cartridge to mate with it. As far as the weight goes, you will have to get the effective mass figure to determine the resonance requirement.
cartidge recommendations needed
Hi all, I am looking for a good match for a Clearaudio TQ-1 tonearm. I am currently set up for MM cartidges and would rather not change yet. Price range about a kilobuck. The turntable is my own design ; well, barrowed design from some of the best anyway. No springs but well dampend and built into a 1925 RCA Victrola cabinet. Anyone using a TQ-1 tonearm with a MM cartidge please respond with your advice and practical setup experience. I have also wondered if the Cardas cartidge may be an alternative. Thanks,Dredster