This may be completely unrelated and I know nothing about electronics but, I was an air conditioning tech for 40+ years. There is a weird thing that can happen on 480 volt ac units, if the capacitor for the outdoor fan motor goes bad, the fan will run backwards. Maybe you have a failed capacitor on the mid-range driver that is responsible for the problem. I have no idea if this is even feasible or not.
Can hardware change speaker phasing over time??
After years of great listening, I suddenly noticed I wasn't getting the sharp center image with vocals. I spent hours moving the speakers and even did Room EQ on my Denon receiver (which normally would tell me if speakers are out of phase). The vocals sounded diffuse. Finally, I switched the wires on one speaker. BOOM! Right back to crystal clear center imaging on vocals, on all of my favorite tracks. I've checked all the wires. Everything is hooked up right, though now red is hooked to black on one speaker.
Could something have changed the phasing in the hardware? There is no other place in the set up the wires could have been reversed. I have triple-checked that the ++++ cable is connected to the red output on the amp.
Signal goes from Mac Mini by USB to Bryston DAC, by two single channel cables to Denon receiver, by two single channel cables to Parasound A21 Halo amp, by speaker wires (one wire marked ++++) to B&W CM10s.
Could something have changed the phasing in the hardware? There is no other place in the set up the wires could have been reversed. I have triple-checked that the ++++ cable is connected to the red output on the amp.
Signal goes from Mac Mini by USB to Bryston DAC, by two single channel cables to Denon receiver, by two single channel cables to Parasound A21 Halo amp, by speaker wires (one wire marked ++++) to B&W CM10s.