2. cables
  3. 133032-95382

Can cables of any cost and quality provide bass response missing in my B&W speakers?

I'm sure variants of this question have been offered previously, but let me ask in light of the following:  I have a very modest main system powered by an Adcom 555II amp, Adcom GFP-750 pre-amp, and run into a pair of B&W CM-4 speakers (6.5in woofer, 6.5in. woofer/mid. and tweeter, and bi-wireable).  Any music with a moderate-to- heavy bass component (organ, bass fiddle, etc) just doesn't translate to my ear.  I'm using a mid-range pair of Monster cables, and in fact tried a second pair of Z-Series to no audible difference.  On the other hand I have a legacy pair of a/d/s 1090L tower speakers (2x7.5in woofers, 6in. mid-range, tweeter) that deliver thundering bass when needed regardless of cabling used, and powered by the same system.  Even tried passive bi-amping for the B&Ws by using an old Carver M-500t amp for HF input, and Adcom amp for LF input...no diff.  Is there any point really in looking at higher-end speaker wire of, e.g., thicker gauge, or exotic geometry, or multi-conductor "shotgunning", whatever, in order to induce greater LF response from the CM-4s?  Thanks for your patience.
compass_rose

Showing 1 response by genez

genez
220 posts
 
Compass_Rose. 

Others here spoke of "polarity."  But,  what I can gather from what they spoke of?  Was to check the "phase" to make sure both speakers are wired the same.  You may find if you reverse both speaker's leads - red to the black, and black to the red-  that will reverse polarity.  If one pair of speakers was designed with reverse polarity one pair will produce less bass.   Simply reverse the leads to BOTH speakers.  Then listen.  Correcting the polarity should produce more bass.
More to discover