Cadenza Bronze on a Fatboy


I have a question about how close the bottom of my Ortofon Cadenza Bronze is to the surface of the record. I’m using a VPI prime signature with the fatboy gimbal arm. I have used a Wally reference jig to perfectly set the arm level to the platter. After mounting the cartridge there is barely a gap between the record surface and the cartridge body. Is this normal? It’s not rubbing. 

128x128travisg

Showing 1 response by mijostyn

@travisg , "Am I in trouble?" Did you shim the height of the Wall Reference to match the height of the mating surface of the cartridge from the record with the stylus in the groove with proper VTF set? If so than as long as the Wally Reference sits perfectly flat on the record in both directions you should be in good shape with an Ortofon. As long as a warped record does not launch the tonearm it is OK. 

There is always the slight chance that it is a defective or damaged cartridge, but there is no way for any of us to know that without an obvious defect which I assume you would notice, it being obvious.