Call me crazy but I did some cable management work last night based on suggestions in this post. Basic stuff...got the speaker wires off the floor and separated them from power cords and interconnects. Re-routed some of the interconnects so they didn't touch and didn't run as parallel as before. Took maybe 10 minutes, a couple pieces of string and a handful of rubber bands. What I can say for sure is that immediately following the cleanup my system sounded the best it's sounded in a while...if not ever. I guess some could convincingly argue that there could be multiple reasons for the perceived improvement, but my favorite is that cable management actually does make a difference. I'm headed to Home Depot today to pick up some of that foam based pipe insulation to compete the task.
One question I still have is this....I get how running a speaker wire next to a power cord could create a problem...but what I'm wondering is whether a pair of interconnects...say R/L channel to a single source...will also benefit from the advice (don't run parallel). I look at the back of my DAC and the output jacks are in parallel. I look at my fancy pre-amp and not only are the input jacks in parallel but they are all stacked very closely together. So I'm thinking maybe interconnects, because of the low signal voltage/current/whatever...don't have the same problem? Or do they?
One question I still have is this....I get how running a speaker wire next to a power cord could create a problem...but what I'm wondering is whether a pair of interconnects...say R/L channel to a single source...will also benefit from the advice (don't run parallel). I look at the back of my DAC and the output jacks are in parallel. I look at my fancy pre-amp and not only are the input jacks in parallel but they are all stacked very closely together. So I'm thinking maybe interconnects, because of the low signal voltage/current/whatever...don't have the same problem? Or do they?