Cable Goop Review George is going to freak!!

Have been using it and it works great. well worth the price-component up grade that good.

rocray
I have used NPS 1260, and its great. I tried it just on my speaker cable speaker end first. If i did not like it i wanted to be able to remove it. Less than 2 days later i was doing the other end of my speaker cables. My speaker cables are Transparent Reference. I have applied it to all my power cords and XLR interconnects,  speaker jumper wires. It just got better  sound across the board.
Try a solid thin coat first you can always go back and add more. The thicker the coat the longer the break in was for me. I did go back and make it a little thicker coat with time.
Stir it well before applying, wipe off all  your connection first before applying.
Good luck

+1 Ozzy

kimurastanley
If you unplug and replug cables a lot, you may need to retreat the cables or power cords. Coating over a coat does not hurt, it will take longer to sound good.

marc777
Thanks for the info

Just add the NPS to new   MC1 Pro wave guide and plugged it in.  The other MC1 Pros in my system took 20 hours or more before the sound got good. With the NPS it sound good right away.

from High Fidelity direct

And what did you hear or not hear?

Hello ozzy
Thanks for the update- no i am all solid state- but have done the entire system and very happy with the sound.

tonywinga
I would start at the speaker cables. Doing just the speaker ends first, to see if you like it. I started there and then did my whole system about 4 days later. very happy with the outcome. Doing it in stages will slow down how fast the improvement  is, But its good to hear it develop in stages.

It only gets better with full treatment

Just treated my new MC O5s Helix Plus Signature with the 1260. And I am hearing better sound across the board . I have had the MC O5s Helix Plus signature in my system before and with the 1260 treatment the sound is better than with out.