Budget amp for NS-1000. Rotel, march or parasound?

Music Fidelity A3cr and A3.2cr are good valued amps. One might be the ticket to relaxing highs while tightening up bass with the Yamaha's.

I had the Parasound A23 lying around here so decided to give it a go with XLR cabling and good speaker cables. I really felt the in your face feeling you described, highs were unbearable, really sharp, some bass but not worth it to be honest.

Plugged the Crown XLS 1500 back and it sort of feels like heaven. Everything is more controlled. Of course the floor noise was there when I connected it and the interface was off, but whatever, I think it's worth it. 

I think I'm done trying amplifiers after this, maybe if I get a Crown XLS 2500, but I'm wary of blowing the speakers using that much power. 

I got a Dynaudio Center LR120 (or C120) to go with this setup. I sort of owe my audio dealer (the A23 is his), feel like I should buy something from him, but what I really want is to get another cheap Crown and rack on top of the one I got to drive the Dynaudios. 

thanks for all the advice...

if it helps, some good songs to test speakers are made by the artist Woodkid. Try Iron or Run boy Run, really hard for these to sound sublime...

So, I tested the XLS1500 and it's nice, but now I want to test another high end amplifier. Should I go for Marsh A400S, Rotel RB1080 (roughly same price) or Rotel Rb990BX (Half price)?

I need maximum detail and plenty of bass... 

After reading this thread:

http://www.hometheaterequipment.com/mono-stereo-amps-59/crown-audio-xls-drivecore-series-amplifier-o...

I’m pretty much sold on Crown amps... I must try them. Now, I feel I must follow Audiogon forumers advice as it has always been good advice (which I not always followed), so I have the option of getting a XLS 1500 used ( I have no issues with used gear, but what possibly is PA gear is another story...) or a new XLS 2500 for a 70% higher price. (roughly 600 vs 350 dollars).

My question is, the 2500 is good or should I stick to the 1500? Remembering my Yamaha is rated 100w max and I’d hate to overload it with this pro gear experiment...

Yea, I could get an used unit of the XLS-1500 for about U$400.. Which is about half of the Rotel RB990... To be honest I want the best solution, when I say budget I mean I don't want to shed U$2000 on a Bryston... Anything up to $1000 stretching a bit is acceptable, as long as I get the bass out of the Yamaha NS-1000 with good detail and clarity, demanded for my production needs...

It sounds like the Rotel might have some technical problem or the speaker polarity was wrong, or maybe both.

Pro amps are for some while not so much others. One I can live with is my crown XLS-1500. You could probably purchase one new within your budget plans if there are still some available. The XLS-1000 has somewhat different circuitry and you might not like it for more serious listening.

The salesguy brought the Yamaha NS-1000 and two amps, Rotel RB970 and the A23... He plugged the Rotel first and after I disconnected my Dynaudio BM12A and listened to the NS-1000, it seemed like I was listening to a bad radio station, really poor definition and no bass at all. Then we installed the A23 and things improved.

I have the A23 here still, but am using the HCA-2200II, I like this but the A23 seems better (and louder) despite being less powerful in RMS output.

Still, I'm not 100% satisfied, plus the A23 is a bit expensive and I use the 2200II in my B&W setup so I need another amp. I'd be happier paying next to the A23 price for the Marsh (my bad for March) as long as I hear a good word on them. I considered the Rotel 990BX because it's available really cheap (USD400 less than the Marsh) and more powerful than the 970BX. 

In another forum some guys suggested my using a pro audio amp like QSC or Crown on the Yamahas and I am also considering that now... Any ideas?

thanks for the answer

I’ve never played Marsh amplifiers but can and will say some of the earlier John Curl Parasound is excellent bang for your buck, not easy to surpass. When trying to fit that criteria I would not hesitate on them. Or NAD should the opportunity arise. Hafler is another. Rotel would be lower down on my short list but on it just the same, maybe not that particular model. Going by some of your other choices I’m going to go and assume the RB970 lacks the power you want, what don’t you like about it?

I have a Bryston 4B, that I paid $450 for. That will happily/easily drive some demanding speakers all day/night long. It may not be the best choice with your Yami speakers reason being it can be bright with certain set ups. While with others its very deserving of praise.

It's Marsh, not March and it's a great amp.  Many excellent reviews. That would be my choice of the options you listed.