Bryston 4B gets HOT. Should I leave it on?

Pops: Keep your money and your sanity. Your probably better off with what you have : ) Sean
>

If indeed your amp is not working properly and if something in the amp were to fail during operation the amp could go DC. This would destroy any speakers hooked up to it. Then you would not only be out an amp but a a set of speakers also. A Bryston amp going DC would de especially bad with it being a class A amplifier. There is no reason for a bryston to get extremly hot unless they are out of normal working order. I have 3 Bryston 4B's in the theater I work in, They are on 365 days a year and work fine. But then again I have had a bryston get so hot inside it turned the fiberglass pc board into ash from what looked like a small fire. If suspect a problem with any Bryston I stop using it and send it in for service. An ounce of prevention is worth apound of cure!

Cheers!

Just the thread I need. I've got a pair of 7BSTs which I've had since 1996. One of them gets so hot you cannot keep your hand on the front let alone the top without burning it after about 30 seconds. It has always been too hot but now that I'm using it with my home theater it is over the top hot. After being on and driven for three hours it is bad.

Should I just sent it back to Bryston? Any other suggestions?

Thanks in advance.
Hugh

Yes Hugh, send it in for service!

I run a pair of 7B-ST's & after a 2-4 hour listening session they only get warm to the touch.

I would stop running it, you may wind up doing more damage if you don't.

Agreed, I haven't turned it back on after it did that twice. Warm would be fine but not this. Hopefully I don't already have damage.

Hugh