Bowling alley lane wood for component tables?

Dusty is correct in that bowling alley flooring could be either maple or pine. I made a woodworking bench from bowling alley flooring and the individual wood strips where glued and nailed together. I found out the hard way when I began to cut through the stuff and sparks flew. So watch out for nails and good luck.

Yikes!
Thanks Hank. I forgot about the nails. Most new lanes (well, new 20 years ago) were glued and nailed together. A 3" thick bed had the 1st 1-1/2" studded with nails. This side was laid down on the bottom crib or floor. Thus, when the lane was sanded to remove the "grooves" you didn't hit any nails. When the sander hit nails it was time to replace the whole lane bed. If you drill into your piece be sure to use the side that has the finished surface, and limit your depth to about 1/2".

Hello everyone,
Thanks for your comments. Yes, the bowling alley wood is maple and there are no nails in it or nail holes. It consists of inch and a quater lengths that are about an inch and a half thick, then glued together. The pieces are solid and heavy. I am gonna go ahead and make the component tables out of this stuff.
So the next step is decided on the feet. Do I use spikes and what kind, or do I use some kind of sorbethane feet?
I am making it for a Rega Plana 3 table, which picks up my steps when I walk on the wood floor in my living room. I think I will also make one for my Magus preamp and my Rotel CD player.
Cheers,
Joe