Boltz CD racks?

I have a Boltz cd rack too.Loaded with cd's shouldn't tip over,unless it gets pushed.They have the feet that stabilize them further.Mine sits on hardwood floor however.I thought the assembly was time consuming.Yes one side panel arrived with a slight curve obviously from shipping but no big deal,and once put together the curve goes away.
You can order direct from Boltz.They run specials all the time and once you becomer a customer they keep e-mailing you with product update announcements.
Good luck
George

Don't understand how wall bracket works. Fork of bracket is meant to ride the rod but the only place this can occur, for it to be pressed and not slip out, is between the threaded wing nut and the acorn nut. To do this, you would have to jam the fork into the threaded end of the rod which basically ruins the threading and offers a very poor solution for adjustment, etc.

Also, CD's do fall over the edge whish is a pain and instructions are not very clear. All in all, I'm not satisfied with the Boltz CD Rack and don't understand why it is recommended by Stereophile.

Interesting responding to a thread where the last comment was over 7 years ago. No matter, I have both the largest CD rack & DVD rack doubled up and have never needed the wall bracket. As to why I like them, they are minimalist looking which I like, & frankly, I hate the look of wood.

Skipnie, I'm sorry that you're having problems with your Boltz rack. Is it possible that you have it tilted a little towards the inside of the room if your CD's are falling out? I never had that issue.

Boltz has good customer service, so just call them or send them an e-mail if you have any questions.

Michael

My Boltz rack sits on a wood floor... I put little clear plastic bumpers under the legs to tilt them towards the wall.