2. cables
  3. 1068274355

Biwiring B&W Matrix 802 III with Kimber 8TC & 4TC

Is it a good idea to biwire my B&W Matrix 802 III with Kimber 8TC (low) & 4TC (mid-range & high).

I'm using single runs of 8TC right now. I thought that adding a ma 4TC cable for the mid+ tweeter I can improve the ambient resulution, but I'm worried it may make the system sound brighter (especially since the mid-drever will also be fed by the 4TC strand).

Any advice
reonb3752
4 responses Add your response
philjolet's avatar
philjolet
2,306 posts
 
I would sell the 8TC and buy a better wire (like AZ Satori) and run it single for about the same money as the 2 you mention, which are a little thin sounding for my tastes.
thorman
1,262 posts
 
For my 801 Matrix I used A/truth Agent ( mid -top ) and Midnight+ ( lows ). Worked very well.Not all that expensive either...
Post removed 
james37
11 posts
 
I am currently biwring B&W Matrix 802 III speakers with Kimber 8TC(low) and 4TC(mid/hi) and I like the sound.
I previously biwired low and mid/hi with 8TC but I like the 8TC/4TC combination better. It is less bright than all 8TC and the bass seems a bit more prominent.
I once had the B&W's single-wired with 8TC, but that was several years ago. As I remember, moving to biwiring was a significant improvement.
Log in to respond
More to discover
80x80
Synergistic Research SRX Speaker Cables
80x80
Avanti Audio Vivace Ethernet
80x80
ANTICABLES Level 3 "Reference Series"
10 Foot Speaker wires