Your in a tough position. Budget wire connectors,no soldering abilities,no room to work. I guess that is between two rocks and a hard place.I'm not to sure that if you actually paid someone to do all this there would be significant gains anyway.Sometimes, one good wire, properly terminated, with a good connector, is all you may need.
biwire question - 2 cables - 1 banana?
I want to biwire my speakers using 2 runs of linn k20 wire. Right now, I am using one run that is plugged into my rega mira integrated amp using rat shack banana plugs. I bought the other run of cable, but left the amp end as bare wire.
My question is, should I buy a set of stackable banana plugs for the new wire and plug the rs plugs into them, or should I get rid of the rs plugs, and put both bare wires into one quality banana that could hold them both (no soldering, please)? If so, any suggestions on which banana plugs could hold the 2 12guage linn wires?
Spacing concerns and inflexibility of the cables eliminates the plausibility of using spades. Thanks for your help.
My question is, should I buy a set of stackable banana plugs for the new wire and plug the rs plugs into them, or should I get rid of the rs plugs, and put both bare wires into one quality banana that could hold them both (no soldering, please)? If so, any suggestions on which banana plugs could hold the 2 12guage linn wires?
Spacing concerns and inflexibility of the cables eliminates the plausibility of using spades. Thanks for your help.