2. cables
  3. 138531-115778

Bi-Wire Advice for ProAc Response D2

Greetings from a new Audiogoner.  Recently acquired a pair of ProAc Response D2 via an Audiogon member.  Am thinking about bi-wire for these and am interested in any recommendations the community may have.  I currently have a Cambridge Audio 651A integrated amp (until I upgrade of course).

I'm thinking that Kimber Kable 8TC might be a candidate but I wanted to tap into the experience of this forum, even to hear whether you think bi-wiring is necessary.

Thanks in advance for considering.
goethe58

Showing 1 response by akg_ca

akg_ca's avatar
akg_ca
2,386 posts
 
This is a well-travelled off-repeating question dissected in AGON and just about every other audio forum.

Here is one on AGON worthy of prior research that is readily available in your journey

https://forum.audiogon.com/discussions/bi-wire-or-not-to-bi-wire

In brief:

(1) It is always system dependent as best evidence ,

(2) Without prejudice of the above, an increasing number of major manufacturers are advocating a best-of-breed single run and jumpers array.

CHORD even stopped making dedicated bi-wires.
More to discover