Bi-amping Rules


I wasn't sure if this question belongs in the amp or the speaker section but I figured I'll post it here. Those of you who have bi-amped your speakers, what's the general rule for deciding which amplifiers are better for low frequency vs. the high frequency drivers. I recognize an accurate answer will depend on the particular speakers and amp combinations but I'm looking for general rules of thumb from personal experiences and not application specific recommendations. For the sake of the argument, let's assume the amps are different but the gains on both amps can be adjusted if that matters. Thanks.
128x128kalali
VX-5 Twenty is a stereo amp. The Next is MXR - a lot expensive. But ok - incredible. 

I dont see any alternative to VX-5 twenty. I can pick up AR 150se but no sure that makes sense. 

gibalok
16 posts03-14-2020 5:45amVX-5 Twenty is a stereo amp. The Next is MXR - a lot expensive. But ok - incredible.

I dont see any alternative to VX-5 twenty. I can pick up AR 150se but no sure that makes sense.
I don’t see why not, then use the AR150se on the mids and highs and the Ayre VX-5 on the bass, and this time horizontal bi-amp, as I outlined here, at the end of the post
.https://forum.audiogon.com/posts/1861204

Cheers George

Post removed 
@gibalok did you ever try to bi-amp with your VX-5 Twenty?  I have the same amplifier powering my Legacy Focus SEs.  Although it sounds great, I want to experiment with passive bi-amping the bass drivers with a Class D amp.  I do have on order a 7-channel HT amplifier from D-Sonic.  It also has 26dB max gain like the Ayre.  It will be 800w/channel compared to Ayre's 350w/channel, so it's a bit over the 2:1 ratio.  But I'll try it when the D-sonic arrives and if I don't like it for the better, then nothing gained, nothing lost.  It was bought for my center, surrounds and atmos speakers anyway.