I would suggest going to Home depot and picking up 2 - 28ft runs of cable and 1 - 6ft run. That way you can compare 2 equal long runs of cable vs a long and a short runs. Even if you hear no difference you haven't spent a lot of money to answer you own question. Also never coil a cable because it acts too much like a coil choking off power. Instead run the cable in a zig zag pattern
Bi-Amp v. Uneven Speaker Cable Runs (Pass Labs B&W 802D)
Hello - I have a system in my living room where I can not center the equipment in-between the right and left channel (fireplace in the way). The equipment and amp are 5 feet away from the right channel, and about 20 feet away from the left channel. Right now I am running a 30 foot pair of low end Monster Cable to each speaker until I can figure out what I want to do long term. This 30 foot pair gives me about 4-5 feet to spare on the left channel, and 20-23 feet to spare (coiled up) on the right channel. Not ideal in many regards.
Equipment: Classe CP-800, Pass Labs XP-15 Phono, VPI Super Scoutmaster with Lyra Delos, Marantz NA-11S1, Pass Labs X-250.5, B&W 802D, Audio Sensibility Statement SE XLR and RCA cables.
I am torn between the many options to deal with this, and could use any advice given (or other ideas of course):
Option 1: Pick up another Pass Labs X-250.5 and vertically bi-amp. Run a long XLR to the left channel (25 foot), and a shorter XLR to the right channel (5 foot), and get a shorter set of identical length speaker cables. Am I gaining anything from this?
Option 2: Run non-identical length speaker cable, 28 foot to the left, and 6 foot to the right. Besides saving money on the right channel cable, I am not having to coil up (or deal with) a massive amount of unneeded extra cable.
Thoughts?
Equipment: Classe CP-800, Pass Labs XP-15 Phono, VPI Super Scoutmaster with Lyra Delos, Marantz NA-11S1, Pass Labs X-250.5, B&W 802D, Audio Sensibility Statement SE XLR and RCA cables.
I am torn between the many options to deal with this, and could use any advice given (or other ideas of course):
Option 1: Pick up another Pass Labs X-250.5 and vertically bi-amp. Run a long XLR to the left channel (25 foot), and a shorter XLR to the right channel (5 foot), and get a shorter set of identical length speaker cables. Am I gaining anything from this?
Option 2: Run non-identical length speaker cable, 28 foot to the left, and 6 foot to the right. Besides saving money on the right channel cable, I am not having to coil up (or deal with) a massive amount of unneeded extra cable.
Thoughts?