Best way to dampen a micro-vibrating Printed Circuit Board inside an amp? Thanks!

@yoyoyaya 

The best answer yet. After filling with lead shot, chuck it all in the sea gangster style. That’s the best way to get rid of problems.

@yoyoyaya Tony ha ha ya ya

This discussion is as nuts as mine. I think it may be a good idea to start another one…..”Are there any amplifiers you just can’t listen to?”

The OP avoids direct questions so perhaps the amp should just be buried along with the hidden evidence asked for.

I’m thinking of good vibrations… it’s giving me ex-cit-tations… blab blab blab blab.

@yoyoyaya Holy Grail Record

Do you remember a previous discussion about a rare $1,200 record for customs declaration. We never found out what that record was either.

@panzrwagn “what frequencies did the micro-resonances occur?”

Don’t hold your breath or bank on an answer

 ”What is a recommended way(s) to dampen” discussion question

@kennyc  “Apply water;-“

Yes, some of us had a few laughs along the way with this discussion, but “we have (all) passed a lot of water since then”. Goldwynism