Best kept secret in AC line filtering conditioning

@thyce, if your 15 amp breakers are tripping then change them for ones with a different trip-curve. The breakers are thermomagnetic devices. The magnetic side will cause instantaneous trip like in a lightening strike, the thermo side will heat up and cause a bimetal strip to open-circuit the breaker. The trip-curve determines the time and amount of overcurrent allowed before tripping.

I don't know about regs in USA but maybe upgrading to 20/25A breakers with a slower trip will not only provide uninterrupted service but better dynamics too. Go as high as the house wiring or wiring regs will allow.

@cleeds, you not only have things backwards but upside down, back to front and inside out :)

You also state: " And of course the power cord will need to be changed to have the proper connector for the 240VAC service."

The IEC receptacle is an industry standard that is used for connection to the mains regardless of countries' voltage. Think about a device that has the ability to be used on either 110V or 230V by internally connecting the transformer primaries in series (230V) or parallel (110V)  do you find two different IEC connectors on the back panel???

@thyce  Thing seem to be quite different in the US to the UK this is a typical UK consumer unit with the usual value breakers for a there bedroom house. https://cursorium.co.uk/uploads/consumer_unit.jpg

lemonhaze

@cleeds ... You also state: " And of course the power cord will need to be changed to have the proper connector for the 240VAC service."
The IEC receptacle is an industry standard that is used for connection to the mains regardless of countries’ voltage. Think about a device that has the ability to be used on either 110V or 230V by internally connecting the transformer primaries in series (230V) or parallel (110V) do you find two different IEC connectors on the back panel???

Hey @lemonhaze: Think about your typical power cord. You’ll note it has a connector at each end of the cord. One end goes into the wall for AC power. Connectors for 240VAC supply are different than connectors for 120VAC supply. That is why I stated that the cord will need to be changed to have the proper connector.

@lemonhaze,
I concur