Best cable for short monoblock runs?


My blocks are elevated so that I only need 15" or even 12" of cable. I've done a lot of DIY experimentation with short and more conventional (2 meter) lengths and results suggest the composition and configuration of short runs may be more critical than long runs.

Probably my best short run results were with 4 - #24 bare Cat5 copper runs for each leg, spaced widely apart, like a fan. 8 wires total.

Your experiences, suggestions? Doesn't have to be DIY. Commercial is good.

I've tried Jon Risch's 89259 2 meter runs -- not too impressive, to be polite. I just ordered a 2 meter pair of Signal Ultra cable. I'll use long runs over that short 12-15" distance if results are superior. May as well put the blocks on the floor if I do.

I'm using DIY monoblocks now but have a pair of Clayton M200s coming soon.
Regards,
Dave
interlochen

Showing 3 responses by muralman1

Stringreen, actually there is for short runs, and it isn't commercial. Cardas is just awful, if you insert it anywhere in a really revealing system. I know, because I tried it. Of course, if a person's amps throw off objectionable HF sounds....

I use very thin, .003" 12 gauge copper ribbons lightly wrapped in Saran Wrap to prevent shorts. The sound is thrilling in it's stage depth, and optimally realized bass and treble extensions.
Wow, a lot has past since I introduced the copper ribbon. I teased my 12 gauge ribbon from a Goertz 12 gauge ribbon inductor. It is about 2 inches wide, .003" thick, and all nines pure.

I use plain old Reynolds Aluminum wrap cut into ribbons for the return to the amp. Yes, aluminum sounds ghastly. The amp has never complained though. :-)
Do it the other way around, and you have trash to hear. The fact is what goes to the amp is grounded. There is absolutely no reason to give wasted signal a royal coach ride to the graveyard. I got the idea from my speakers. The bass ribbons are aluminum, and the music exits through, you got it, aluminum ribbon down the 5 feet of the speaker.