2. amps-preamps
  3. 132678-90784

Best amp to power Krell LAT 1000s? Krell Evo One, 575, Momentum, ASR Emitter II, MSB 203?

I have a pair of Krell LAT 1000's along with the Krell MRS and am looking for the perfect amp to drive them mains.  Have not been able to personally evaluate whether the Evolution One's construction is so matched to the LAT 1000's that they would be better than the new Krell 575's, Dan's new line (Momentum 300s) or perhaps the ARS Emitter II Exclusive (Blue) or the MSB M203's?  This is my condensed list of choices, though I'm enjoying the selection process and won't rule out new contenders.  Any input is appreciated.  My taste in music is wide ranging, from classical, to jam rock, to country, excluding only "death metal."  I'll probably be building out a new room for this setup at some point too.
theoriginalsmith

Showing 3 responses by georgehifi

georgehifi's avatar
georgehifi
10,312 posts
 
The ASR uses Mosfets, and this "could" be an indication of limited current drive as tested by Stereophile. Doing 285w into 8ohms then only 128w into 4ohms.

" The bottom trace was taken with both channels driven into 8 ohms; it stops at 285W (24.5dBW), which is where the amplifier shut down, not where it clipped. Subsequently tested with both channels driven into 4 ohms (middle trace), the ASR shut off at 128W."

Cheers George

georgehifi's avatar
georgehifi
10,312 posts
 
theoriginalsmith OP4 posts12-03-2017 6:42amGot it. Thanks, George! I know the Momentum 300, the Evolution One, and MSB can double down to 2 ohms, and the ASR pushes all the way down to 1 ohm. I believe the Krell Solo 575 goes down to 2 ohm as well.

Best, Justin


Pick your poison. My suggestion would be to look at the ones with the most Class-A bias, as from reports the LAT’s can be a little clinical, more Class-A the better to counter this. 

Cheers George
georgehifi's avatar
georgehifi
10,312 posts
 
There's no impedance vs -phase graph done on these, but if they're anything like the LAT1, you'll need an amp that is known for it's current delivery.
  
Things to look for, independent test on the amp that state it can almost double it's wattage from 8ohm to 4ohm to 2ohm, (eg: 100w 200w 400w.)

This means amps with bi-polar output devices, as mosfets, tubes and most Class-D's have a hard time doing these these sort of figures without BS'ing by the manufacturer.

https://www.stereophile.com/images/archivesart/KreLATfig01.jpg

Cheers George
    
More to discover