Best amp for Wilson sasha DAW

Thank you so much for getting back to me.  I really appreciate it.  Sounds like I should look into alternatives.  One follow-up though (in case you happen to see this), am I right to conclude from your comments that I'd be better off just using one of the Nagra MSA's to power these speakers until I find a replacement amplifier?

FWIW, I haven't purchased the speakers yet, so this is very helpful in terms of thinking about total budget and whether I'm willing to spend the money.

Thanks again,

Mark

monjovi
am I right to conclude from your comments that I’d be better off just using one of the Nagra MSA’s to power these speakers until I find a replacement amplifier?

If the one stereo amp has enough wattage for you and you get the volume you need comfortably without taxing the amp, then I say a definite yes.
As bridging amplifiers has one plus only, increasing the wattage.
Everything else takes a hit.
1: distortion goes up
2: not as stable into low impedance
3: damping factor is doubled (worse)
4: the ability to drive low impedance’s is not as good
I’m sure there are others I can’t think of right now.
I jokingly say, bridging a good stereo amp turns them into a high wattage PA amp.

Cheers George

Very interesting...thanks for you help!

I liked the Constellation Taurus with the DAWs.  Extremely well controlled, transparent and highly dynamic. The Taurus monoblocks have huge headroom which bring the Sashas alive.

The best combination I know for the WA is VTL power amps and ARC pre-amps.I have the WATT/Puppy 5 with VTL MB450, ARC LS25 II, and ARC DAC9.
It’s really good.WA are known for using VTL Siegfried power amps as one of their reference amps.
As for ARC power amps you can’t go wrong with them, but the VTL’s may have the edge in grip, bass and power.
Cheers