Before breaking my Glider, I recall loading to 1000 ohms made the cartridge "less hot" (as a friend described it). I had forgotten that my then Pass Labs Ono had loading options was it was like getting a free upgrade! My Clearaudio Discovery wound up at about 400 ohms. Then I got a Atmasphere preamp and in short order had the terminals installed to allow loading. I don't recall there really being a sonic difference when I did and about a year or so ago I removed them altogether and thusly defaulting to the 47,000 ohm standard. I want to say the sound is a little "more open" but won't swear to it. I'm certainly no worse for it and if anything, another "thing" has been removed from the path which is always good, IMO. Perhaps Ralph is correct about it not making a difference in his preamp. By all means experiment, but don't be afraid to try no loading at all.
Benz Micro Glider Loading
Hello,
I have an original Benz Glider. The measurements that came with the cartridge is .9mv and suggested loading is 1000-47k.
I ran this into a Krell KSL w/phono stage at 1k with good results.
I’ve also ran this into a Rogue Audio Model 99 Magnum with tubed phono and Hagerman Piccolo head amp at 1k with good results.
Right now, I’m using a MoFi Studio phono pre and am running it at 1k.
I’ve tried higher and lower load settings and to my ears, 1k seems to be the sweet spot.
I’ve been looking at phono pre’s on Audiogon and USAudiomart. I noticed some of them don’t have 1k loading as an option.
Should this deter me from considering these units?
I noticed after doing some research that others have been running their Gliders at much less than 1k. I found that running it much below 1k kind of sucked the life out of the sound in my experience.
I should mention that I had the Glider retipped with a micro-line stylus profile. The original was elliptical.
Admittedly, I may not understand loading and how it works as well as others. I can only go by what sounds good to me.