Benz Ebony LP loading


Has anyone experimented with the loading of the LP? It says greater than 500 ohm. The Ayre K1xe can do 499 ohms, but I'm thinking that may be too tight. Has anyone done any experimenting??
stringreen

Showing 6 responses by gregadd

I used to think that my preamp was capable, until I tried the stepup transformer.
When you went from the "H" to "LP" H=2.5 mv output to .35mv
(http://www.musicalsurroundings.com/cartr.html)
That is a factor of almost 100.

Insufficnet gain in the phono stage manifests itself as a lack of "slam." Did you have to turn your volume higher than with the "H"?
I still think gain is your answer. It is the only significant change between the two carts. It(gain) has always been the source of my disappointment with low output mcs'. The output level of the H was like a moving magnet. The Lp is near the lowest you would see in a mc. That has to make a huge difference.

It could also be that I have always found HP's all out recommendations to be highly system dependent. Moreover in upgrading, you expected the the LP to be the same as the H only better. It maybe they went for a diffewrnt sound. I have found this to be frequently true. It is not as easy one might think to design a no holds barred product.