2. cables
  3. 1420903416

Banana Plug Wall Plate w/Cabling

After recently talking my wife into accepting some small floor standing speakers (GoldenEar Triton 7s). The tradeoff is that I have to hide cords and components -- except the turntable. That's ok to have out w/vinyl collection.

So this is what I am planning:

* Run some Belkin wire from BlueJeans directly from the Peachtree Nova 125SE inside of a cabinet, down through the floor, and up into the wall near the speakers.
* Terminate the wire at a banana plug wall plate for each speaker.
* Run a short 1-2 ft banana plug speaker cable from wall to speaker.
* In addition, I have on order the Xantech IR receiver that would be wired to control the Peachtree located in a cabinet along with Rega Fono amp and Apple TV.

So here are my questions:

1) I suspect many on this forum would advise against having a wall plate connection between my amp and speakers. Maybe this is heretical in these parts;) So what are the problems of doing it this way, and is there a better brand/maker for these types of wall plates? The ones at BlueJeans are out of stock.

2) The cable runs to the speakers are of unequal length (20 vs. 10 ft). I am assuming I should run the lengths of wire the same even though one will be much longer -- or is this not necessary?

3). Assuming the amp to wall plate is OK. Does the last stretch of 1-2 ft. cable from the wall plate to the speaker matter in terms of type of cable? Just continue the Belkin?

As for placing the amp in between the speakers, this is not an option with the room layout. Also, I know there are wall plates that just allow cords to 'exit' and keep a single run, and that might be an option, but I know my kids would probably pull on them and push legos into the holes.

Just wondering your thoughts/experiences.
drinky

Showing 3 responses by drinky

drinky OP
15 posts
 
@Theo, yes, being single w/o kids has MANY audio advantages -- not just cabling and speaker related either.

@kgturner, those are the 'exit' wall plates I was looking at but thought they might be too attractive of a nuisance for the kids. When all is said and done, I may just go this route. It will be cheaper and more direct with cabling. I have inspected the crawl space and think that I could retrieve or limit most of the debris deposited by kids through the opening. And eventually they will get bored with the hole that makes their toys disappear.

k.
drinky OP
15 posts
 
That's a good idea Mesch. Thanks.
drinky OP
15 posts
 
In the end I got a few options, but for my speakers I am going to try use those hole covers for desks. They have a two-inch diameter, and I also got a 2-inch hole drill bit, so hopefully all fits well. I also like the small circular look better than bigger wall plates.

Here is what I bought.

http://tinyurl.com/ntudj7d

k.
More to discover