Balanced power amp and subwoofer connection.

Connect the red Speakon wire to the red output terminal of the right channel on the amplifier.

Connect the yellow Speakon wire to the red output terminal of the left channel of the amplifier.

Connect the black Speakon wire to the binding post on the rear of the amplifier that is labelled "ground" or "signal ground" or something similar. DO NOT connect the black wire to either of the black speaker output terminals of the amplifier.

This assumes that you are using just one sub, rather than a separate sub for the left channel and for the right channel.

Can an av and hifi amp be connected to one sub designed for Hifi and home cinema amp connections at the same time.

Looking at the manuals for a couple of the BK subs, it appears that some or all of them are designed to accept high level (Speakon) and low level (RCA or XLR) connections at the same time, with independent gain controls being provided for the high level and low level inputs.

You should not, of course, connect the high level outputs of two amplifiers at the same time, or damage will result.

If the sub provides both RCA and XLR low level inputs, I would also avoid using both of those low level inputs at the same time. I doubt that damage would occur, but depending on the specific design sonics may be adversely affected.

Regards,
-- Al

There are some issues that would have to be considered before driving the sub from the preamp.

Most or all of the BK subs have line-level input impedances of only 10K. The input impedance of your power amp is 30K balanced and 20K unbalanced.

If you use a pair of balanced y-adapters to drive both the power amp and the sub from the preamp's XLR outputs (assuming the sub provides XLR inputs) the preamp would see a combined load impedance of (30 x 10)/(30 + 10) = 7.5K. That is too low a value for some preamps, especially some tube preamps, to drive without sonics being adversely affected. Which preamp are you using?

If instead of using balanced y-adapters you drive the sub with the preamp's RCA outputs (assuming those are main outputs, not tape outputs which would not be volume controlled), and if the preamp does not drive those outputs from an output stage that is independent of the output stage driving the XLR outputs, the balanced signal path to the power amp will become significantly unbalanced (as well as possibly becoming excessively loaded), probably affecting the sonics of the signal path to the main speakers.

In any event, although opinions and experiences differ, many people consider it to be preferable to drive a sub from the power amp outputs, so that the sonic effects of the power amp are reflected in the signals that are received by the sub as well as by the main speakers.

Regards,
-- Al