Balanced connecter output voltage on a Brooklyn + DAC.

I will be contacting Mytek tomorrow and the DAC will be connected to my preamp with balanced cables. Some DAC's like Benchmark have dip switches to set output voltage and i was thinking maybe someone out there knows if the Brooklyn + has a way to control the output voltage on balance output. Thanks for the response nekoaudio.

I did not get a respond from Mytek but i did find this out. This specs are from the original Brooklyn, the maximum output levels at 1kHz were 9.84V from the balance outputs and 4.9V from the single ended outputs. My question is does the -6dB attenuation cut this values in exactly half? So with the internal -6dB jumpers engaged, the balance output would be 4.92V and single ended output 2.45V. Is this correct, if no could some one tell me the voltage for each with -6dB jumpers engaged. Any feed back greatly appreciated! With no jumpers, too hot for me. Thanks in advance! Newbee Joe.

Thank you again nekoaudio!