Audio Refinement Complete 'a' Integrated preouts

Yes, mono amps are the same as a stereo amp, just two boxes instead of one. A stereo amp, of course will have a separate right and left input, (2 total) where a mono amp will have just one.

Remember to keep all the inputs and outputs to the correct right or left channel/speaker.

Mofimadness is absolutely correct with his/her information and instructions. This is one of my favorite integrated amps, the preamp section may surprise you with its quality.

One assumes you've already run the amp as is and now are seeking more power to gain a more authoritative sound. Good luck with your endeavors.

That's great to hear about this particular preamp section Celtic66 as I was going into this absoultely blind (deaf?). And you're absolutely correct, I really enjoy the ARC (except for its start up 'Thump'), but I'd like to feed my speakers (Tekton Lore S's) some more power just to hear how they'll sound.

I plan to eventually go to separates in my main set up and use the ARC in a second system.

I really appreciate the help.

Just make sure the outputs are "pre" outs and not "tape" outs. Pre outs are variable with the volume control while the tape outputs are line outs set at full volume.

I'm doing the same thing now with a Cairn integrated amp. It has two sets of "pre outs." I hook them up to a pair of Dared VP-20 tube mono amps. I switch the speaker wires back and forth between the Cairn speaker outs and the Dared speaker outs depending on which amp I want to use.

I did own an Audio Refinement Complete a few years ago. I really liked that amp.

On the "alpha" version of the Audio Refinement Complete integrated amplifier, you have to hit the "AMP" button followed by the "STOP" button to activate the pre-amp outputs. A relay will click and you'll see a faint blue light under the front of the unit. Pressing the "STOP" button a second time will deactivate the pre-amp outputs. Not sure if this works on the pre-alpha version or not.

Here is the description from the manual. I quote directly, bad grammar, typos, and all.

"IR SENSOR AND PRE OUT INDICATOR: This sensor receives a signal from the remote handset, it also used for the function of indicating pre-out is enabled, as you press the "AMP" button on the remote control and then press "STOP" button, a light blue LED behind the acrylic under the panel will lit up, indicating that the per-out function is enabled. Pressing "STOP" button one more time will turn off the LED and return to the original state without pre-out."

"PRE-OUT: Pressing the remote control of "AMP" button, then press the "STOP" Button, after 3 minutes the pre out function will be enabled, the signal will through volume control and could supply to subwoofer or power amplifier."