2. cables
  3. 158956-46

Audio envy - dang!

I usually post on AG when I have an issue or concern, so I’m happy for once it’s to praise a new product, in this case Audio Envy’s IC. 

I use an ARC Classic 60 amp with a Herron 1A preamp. The AE cable went between these two.

I run an ARC Phono pre PH3se from my VPI prime as source.
My speakers are Thiel CS2.4’s

Out of the box a bit bright, But after a few hours that just went to strait up transparent - I mean freaking crystal clear. No tonal aberrations. Smooth, with no etched highs. Voices sound right, Natural. Soundstage opened up, as you might expect when things get clearer.

The best part was how inexpensive they were. They made my Cardas Clear Light interconnects I was using sound clouded by contrast. The Cardas was about x3 the cost of the AE’s.
BTW, this wasn’t “I think I hear differences”, this was “I’ll never use those Cardas in this system again, and where is my IPad, I need to order my next set!”

And that’s just what I did.
last_lemming

Showing 1 response by gakman

gakman
58 posts
 

About two years back, I had the (Captain) send me a 10' pair of his SP12 and the (new and not yet published) model 34 speaker cables. After trying both sets in my system, I overwhelmingly chose the model 34's. I found them to be much better performers and sent the SP12's back.  

Has anybody compared both the model 34's and the SP14's with optional ground wire in their system? Would love to hear your thoughts on the comparison.

More to discover