Audio Art vs Signal Silver Resolution

Just how long a run of cabling do you need?

You've done the math here, correct?

Not everyone even goes so far as to publish their resistive, inductive, capacitive, or impedance meausrements. These last 3 factors play as much a role as does simple resistance. In fact I'm wondering now how was that 1,000 ft. length of wire measured... laid out flat, or still on the spool? If on the spool I think the measurements aren't 100% accurate.

The long and the short of it however, remains as posted above... try 'em both... send back the one you don't like. At their price levels, worrying about such affairs of measurements is a waste of time. Actually worryiing about such things in general is mroe a waste of time or loss of energy than needs be.

Untill you plug things into your system, you won't really ever know anyways. That's the bottom line far more often than not with gear in general.. and cables especially.

At this level I'd think either set would be a good choice... given the speaker cables are already AA, I'd probably stick with them. naturally, if a window to try is available, why not do so? I know Rob at AA allows such a thing... I don't know about Signals stance on the issue however.

Mixing cables can and will allow some finer tweaking of the sound, however which ones to mix is always a mystery and requires a goodly bit of investigation... trial and error so to speak. Built in synergy usually comes more readily from 'Same - same' throughout.

Later on, if same same is the take here, you can then more easily slip in and out one ic at a time to try gaining some ground towards refining your system.

Good luck.