2. cables
  3. 1142908055

Audience Au-24 With High Current Amp

I've contacted Audience with this question but haven't gotten any response--perhaps the question was too dumb? I've just obtained some large 3.5 way (five driver) speakers to replace some smallish two-ways. I'm now looking at a high current amp to drive these puppies and am looking at my Au-24 wondering if it can carry all the current I'm going to throw at them. They are so thin! Do I need a heavier gauge speaker wire now that I'm going to deliver more current to my new larger speakers?
dodgealum

Showing 1 response by stehno

stehno
1,453 posts
 
You should have no concerns whatsoever. I used to own the Au24s along with my McCormack DNA-2 Revision A amplifier that was capable of 600 wpc into 4 ohm and 1200 wpc into 2 ohm loads and my speakers were 86db sensitivity at 4 ohm.

But then again, your idea of a high current amp may be different than mine.

-IMO
More to discover