2. amps-preamps
  3. 123178-9815

Attenuater Autonomy?

I received a new amp lately (Krell KSA-150), and have it hooked up to my pre, which is a old school AV processor (Proceed PAV). Everything sounds find, but my normal listening volume is between 3-7. I believe that on this unit  I can lower the whole attenuated range of the output signal to the amp, requiring me to turn the pre volume higher and thus make the amp work 'a little harder' to bring the music to my listening range. 

So my questions are 1) by making the amp work 'a little harder' will the music sound any different? I'm guessing no. 2) By doing this, am I burdening my system in any way that may not make a sonic difference. I am also guessing know. 3) The real question is, by doing this will I be able to attenuate the volume in smaller audible steps? Sometimes, my ideal volume really would be between 1-2 for some albums.

The reason I am bothering you all instead of just trying this out for myself is that my pre requires a TV to display its many settings menus, and righteously do not own a TV. I am also righteously too lazy to borrow one from a friend, unless I know for sure that it will work. - Thanks.
ubersujith

Showing 1 response by almarg

almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
For a given listening volume, the amp will see the same signal level at its input regardless of how the attenuation setting in the preamp is set. So the amp won’t be working any harder or easier if you change that setting in the preamp.

But yes, it’s quite possible, and perhaps even probable, that changing the preamp’s attenuation setting (assuming that is possible), such that you utilize its volume control in a higher part of its range, will result in finer resolution (smaller increments) in volume adjustments. It’s also possible that the preamp’s sonics would benefit from doing that, at least slightly, depending on the design of the volume control and attenuator mechanisms.

Good luck. Regards,
-- Al

More to discover