ARC VS60 bias


I just rec'd my new ARC VS60 amp and I think it sounds quite good out of the box. The document says the burn in period is like 600hours!

My question is the bias. The amp out of the box shows 65ma. The manual says 60ma. This is my 1st tube stereo amp so I am looking for veterans advice on where to set it. I suppose the tubes will last a bit longer at 60ma and I should use my ear to judge...
jazzgene

Showing 1 response by rrog

Your AC voltage is higher than the voltage at the Audio Research facility. Lower the bias to 60ma as recommended.

This is not something you do by ear.