ARC recommends a minimum input impedance load of 20k with their preamps. You’re not getting the best out of the Ref 6 with a 9k load. Los your gain is probably too high if you have a 90db higher efficiency speakers
ARC Ref 6 Tube Microphonics
Hi All, I purchased a used Ref 6 preamp a few months ago, initially everything was fine, tube hours indicator said ~950 hours but not sure if that was accurate. After about 50 hours of use, turning the volume past 0 and the mechanical relay kicks in, a chime is heard coming through the speakers. I assumed one or more tubes had become microphonic. I replaced all tubes with new ARC select from Upscale, 7 Sovtek 6H30Pi, 1 Sovtek 6550WE. I let it warm up for a few hours, turned volume past 0 and the same chime is still there. On the positive side, the SQ improvement was immediately noticeable and outstanding, I love the preamp in my setup but the microphonic chime is annoying. ARC service said that some chime is normal but it still bothers me. Any advice? Ignore it? A new set of tubes direct from ARC? New tube rings? Send in to service? Thanks.