Both are wonderful but i would go with VAC for best build and sound quality.
6 responses Add your response
VTL service is first rate if you buy from an authorized dealer. If you are buying used in the open market you may encounter problems. The 450s are very friendly. That is they fail nicely simply blowing a fuse if a tube goes bad. Check the archives for stories of what ARC amps can do in the same situation. The 450s are also very adaptable to suit your speakers due to the adjustable damping factor |
The ARC VT 200 is not user friendly when it comes time to replace the small signal tubes. They have to be biased. Its not for the novice. https://forum.audiogon.com/discussions/please-give-me-advice-about-an-arc-vt-200-amp |
One other consideration -- VTL will insist you use their tubes. A full set for a MB-450 II or III will cost you north of $1600. Using any one else's tubes you will run into maintenance issues with them (I'm not saying they won't work, just that VTL are fussy in this regard). Of course the II and III have full protection and auto-bias so they are a cinch to use but important you have the heads up on cost of ownership Finally on the Gen I -- I'm sure it's still a fine amp, but not reflecting the current VTL design philosophy and outside of a trusted dealer relationship not sure about how easy to maintain it will be (although the design is such that I'm sure any competent tech can do it, I've done routine repairs on my amps myself (replacing binding posts I managed to snap off) so they are easy to work with) |
I called Vtl today and spoke with Bea. She was very pleasant to speak with and quite knowledgeable on their products. I was surprised that on the gen.1 even though there are xlr plugs it is not a balanced input. She asked what type of speakers I would be using these on ( IRS Betas) she recommended 450 Gen 3 or something above and did stress the point of the low impedance loads the Betas present to the Amps. |